Removal

AIR CONDITIONING: CONDENSER (for 2GR-FSE): REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL Removal

2. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM Service and Repair

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

4. REMOVE ENGINE ROOM SIDE COVER RH Removal

5. REMOVE ENGINE ROOM SIDE COVER LH Removal

6. REMOVE NO. 1 AIR CLEANER INLET Removal

7. REMOVE FRONT BUMPER COVER Removal

8. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) Removal

9. REMOVE RADIATOR SUPPORT OPENING COVER Removal

10. REMOVE HOOD LOCK CONTROL CABLE COVER Removal

11. REMOVE HOOD LOCK ASSEMBLY Removal

12. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY

(a) Using a clip remover, detach the 6 clamps and remove the wire harness.





(b) Disconnect the connectors.





(c) Remove the 5 bolts and radiator support.

13. REMOVE LIQUID TUBE SUB-ASSEMBLY A

(a) Remove the 2 bolts and disconnect the liquid tube from the cooler condenser.





(b) Remove the O-ring from the liquid tube.

NOTICE:
Seal the opening of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

14. REMOVE DISCHARGE HOSE SUB-ASSEMBLY

(a) Remove the bolt and disconnect the discharge hose from the cooler condenser.





(b) Remove the O-ring from the discharge hose.

NOTICE:
Seal the opening of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

15. REMOVE COOLER CONDENSER ASSEMBLY

(a) Loosen the 2 bolts on the bottom side of the condenser.





(b) Remove the 2 bolts and cooler condenser.