Removal

BRAKE CONTROL: BRAKE ACTUATOR (for 2GR-FSE): REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE ENGINE ROOM COVER SIDE Removal

4. REMOVE ENGINE ROOM SIDE COVER LH Removal

5. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH Removal

6. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH Removal

7. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal

8. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal

9. REMOVE FRONT FENDER TO COWL SIDE SEAL LH Removal

10. REMOVE FRONT FENDER TO COWL SIDE SEAL RH Removal

11. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal

12. SEPARATE ENGINE ROOM RELAY NO.3 BLOCK

(a) Remove the nut, bolt and engine room relay No.3 block.

13. REMOVE FRONT WHEEL

14. DRAIN BRAKE FLUID

NOTICE:
If brake fluid leaks onto any painted surface, wash or otherwise remove it completely.

15. REMOVE BRAKE MASTER WITH PLATE CYLINDER SUB-ASSEMBLY Removal

16. REMOVE ABS AND TRACTION ACTUATOR ASSEMBLY WITH BRACKET

(a) Release the lock lever and disconnect the actuator connector.





(b) Using SST, disconnect the 6 brake tubes from the actuator assembly with bracket.

SST : 09023-00101

(c) Use tags or make a memo to identify the places to reconnect.





(d) Using SST, disconnect the brake No.3 tube from the flexible hose.





SST : 09023-00101

(e) Separate the grommet and remove the brake tube No.3.

NOTICE:
Do not damage the brake tube No.3.

(f) Remove the 2 bolts, nut and actuator assembly from the body with bracket.





NOTICE:
Do not damage the brake tubes.