Electronically Controlled Brake System

BRAKE CONTROL: ELECTRONICALLY CONTROLLED BRAKE SYSTEM: DIAGNOSTIC TROUBLE CODE CHART

HINT
* If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.
* Inspect the fuse and relay before investigating the trouble areas as shown in the table below.

ABS DTC













1. Drive the vehicle at a speed of 50 km/h (31 mph) and depress the brake pedal strongly for approximately 3 seconds.

2. Repeat the above operation 3 times or more and check that the ABS warning light goes off.

3. Clear the DTC.

HINT
* In some cases, the Techstream cannot be used when the ABS warning light remains on.
* When U0073/94, U0100/65, U0123/62, U0124/95, U0126/63, U0130/68 or U0131/67 is output, inspect and repair the trouble areas indicated by these codes first.

VSC DTC









Electronically Controlled Brake System DTC

















*1: These codes are displayed to indicate the ABS and Electronically Controlled Brake System DTCs.

ABS Test Mode DTC





VSC Test Mode DTC





Electronically Controlled Brake System Test Mode DTC