Removal

2GR-FSE EMISSION CONTROL: CANISTER: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE FLOOR UNDER COVER

(a) Remove the 5 nuts, 4 clips and floor under cover.

3. REMOVE CANISTER

(a) Disconnect the wire harness from the 2 clamps.

Disconnect the 2 quick connectors, hose and connector.

NOTICE:
* Do not use any tools in this procedure.
* Check for any dirt and foreign matter contamination in the valve and around the connector. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the valve and connector.

(b) Remove the 4 nuts, 2 spacers and charcoal canister.

(1) Push the hose firmly toward the canister side.

(2) Pinch the hose (portion A) as shown in the illustration.

(3) Pull out the hose.

NOTICE:
* Do not use any tools in this procedure.
* Check for any dirt and foreign matter contamination in the canister and around the hose. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the canister and hose.