Rear Power Window RH Does Not Operate With Rear Power Window Switch RH

WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM: Rear Power Window RH does not Operate with Rear Power Window Switch RH
- Rear Power Window RH does not Operate with Rear Power Window Switch RH

DESCRIPTION

When the hybrid vehicle control system is running or the power switch is on (IG), the power window regulator motor assembly (for rear RH side) is operated by the rear power window regulator switch assembly (for RH side). The power window regulator motor assembly (for rear RH side) has motor, regulator, and ECU functions.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* The power window control system uses a LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting How To Proceed With Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
* If the power window regulator motor assembly (for rear RH side) has been replaced with a new one, initialize the power window control system Initialization.

PROCEDURE

1. READ VALUE USING TECHSTREAM (Main Body)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Main Body / Data List.

(e) Read the Data List according to the display on the Techstream.

Main Body (Main Body ECU (Multiplex Network Body ECU))





OK:

On the Techstream screen, OK is displayed.

NG -- GO TO LIN COMMUNICATION SYSTEM (Proceed to How to Proceed with Troubleshooting) How to Proceed With Troubleshooting
OK -- Continue to next step.

2. READ VALUE USING TECHSTREAM (RR-Door Motor)

(a) Enter the following menus: Body Electrical / RR-Door Motor / Data List.

(b) Read the Data List according to the display on the Techstream.

RR-Door Motor (Power Window Regulator Motor Assembly (for Rear RH Side))





OK:

On the Techstream screen, ON or OFF is displayed accordingly.

NG -- INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for RH Side)
OK -- Continue to next step.

3. PERFORM ACTIVE TEST USING TECHSTREAM (RR-Door Motor)

(a) Enter the following menus: Body Electrical / RR-Door Motor / Active Test.

(b) Perform the Active Test according to the display on the Techstream.

RR-Door Motor (Power Window Regulator Motor Assembly (for Rear LH Side))





OK:

Rear RH power window operates normally.

CAUTION:
Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function will not operate.

NG -- REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear RH side) Removal

OK -- REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Removal

4. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for RH Side)

(a) Remove the rear power window regulator switch assembly (for RH side) Removal.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for RH side) Removal
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (REAR RH SIDE SWITCH - REAR RH SIDE MOTOR AND BODY GROUND)

(a) Disconnect the power window regulator motor assembly (for rear RH side) connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear RH side) Removal