Removal

2ZR-FXE INTAKE / EXHAUST: EXHAUST PIPE: REMOVAL

1. DRAIN COOLANT (for Engine w/ Exhaust Heat Recirculation System) Service and Repair

2. REMOVE TAIL EXHAUST PIPE ASSEMBLY

(a) Remove the 2 bolts and 2 compression springs.





(b) Remove the tail exhaust pipe assembly from the 3 exhaust pipe supports.

(c) Remove the gasket from the front exhaust pipe assembly.

3. REMOVE FRONT NO. 3 ENGINE UNDER COVER

(a) Remove the 4 clips and front No. 3 engine under cover.





4. REMOVE FRONT CENTER FLOOR BRACE

(a) Remove the 4 bolts and front center floor brace.





5. REMOVE HEATED OXYGEN SENSOR Removal

6. REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/ Exhaust Heat Recirculation System)

CAUTION:
Perform this procedure when the coolant is not hot.

(a) Disconnect the 2 heater water hoses.





(b) Remove the 2 bolts and 2 compression springs.





(c) Remove the front exhaust pipe assembly from the 2 exhaust pipe supports.

(d) Remove the gasket from the exhaust manifold.

7. REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/o Exhaust Heat Recirculation System)

(a) Remove the 2 bolts and 2 compression springs.





(b) Remove the front exhaust pipe assembly from the 2 exhaust pipe supports.

(c) Remove the gasket from the exhaust manifold.