Installation

2ZR-FXE ENGINE MECHANICAL: FRONT CRANKSHAFT OIL SEAL: INSTALLATION

1. INSTALL TIMING CHAIN COVER OIL SEAL

(a) Apply MP grease to the lip of a new oil seal.

NOTICE:
Keep the lip free from foreign matter.

(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the front oil seal retainer edge.





SST : 09223-22010

NOTICE:
* Wipe any extra grease off of the crankshaft.
* Do not tap the oil seal at an angle.

2. INSTALL CRANKSHAFT PULLEY

(a) Align the pulley set key with the key groove of the pulley.

(b) Install the crankshaft pulley to the crankshaft.

(c) Using SST, hold the pulley in place and tighten the bolt.





Text in Illustration





SST : 09213-58014

91551-80840

SST : 09330-00021

Torque : 190 Nm (1937 kgf-cm, 140 ft-lbf)

3. INSTALL REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH Installation

4. INSTALL FRONT WHEEL RH

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

5. INSPECT FOR OIL LEAK

6. INSTALL REAR ENGINE UNDER COVER RH