Installation

SUSPENSION: REAR NO. 1 SUSPENSION ARM: INSTALLATION

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.
1. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

(a) Temporarily install the suspension arm with the 2 bolts and 2 nuts.

HINT
After stabilizing the suspension, tighten the nuts.

2. INSTALL REAR WHEEL

(a) Install the wheel with the 5 nuts.

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

3. STABILIZE SUSPENSION Installation

4. TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

(a) Tighten the 2 bolt and 2 nuts.

Torque : 75 Nm (765 kgf-cm, 55 ft-lbf)

5. INSTALL WHEEL HUB ORNAMENT SUB-ASSEMBLY

(a) Install the ornament with the 10 bolts.

Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)