Removal

POWER STEERING: VANE PUMP: REMOVAL

1. DRAIN POWER STEERING FLUID

2. REMOVE ENGINE UNDER COVER

(a) Remove the 16 screws and under cover.

3. REMOVE ENGINE UNDER COVER REAR RH

(a) Remove the 2 bolts and under cover.

4. REMOVE NO. 1 AIR CLEANER INLET

(a) Remove the bolt and No. 1 air cleaner inlet.

5. REMOVE AIR CLEANER ASSEMBLY

(a) Disconnect the MAF meter connector.

(b) Remove the clamp.

(c) Remove the 3 bolts and air cleaner.

6. REMOVE FAN & GENERATOR V BELT





(a) Set a wrench on the drive belt tensioner set bolt.

(b) Turn the drive belt tensioner set bolt counterclockwise and hold it.

HINT
The drive belt tensioner set bolt has a left-hand thread. The drive belt tensioner set bolt loosens when it is turned clockwise.

(c) Remove the fan and generator V belt.

(d) Release the drive belt tensioner.

7. REMOVE VANE PUMP ASSEMBLY

(a) Remove the return hose, 2 vacuum hoses and 3 clips.

(b) Remove the pressure feed hose union bolt, pressure feed tube and gasket.

(c) Remove the 2 bolts, nut and vane pump.