Removal

LIGHTING: HAZARD WARNING SWITCH: REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
* w/ Navigation System (for HDD):
* After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Testing and Inspection.
3. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal

5. REMOVE SHIFT LEVER KNOB Removal

6. REMOVE NO. 3 BOX PANEL Removal

7. REMOVE REAR CONSOLE PANEL UPPER Removal

8. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER Removal

9. REMOVE RADIO RECEIVER ASSEMBLY Removal

10. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY (w/o Multi-display) Removal

11. REMOVE MULTI-MEDIA MODULE DISPLAY ASSEMBLY (w/ Multi-display) Removal

12. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

(a) Disconnect the connector.





(b) Detach the 2 claws and remove the hazard warning signal switch.