Removal

SUPPLEMENTAL RESTRAINT SYSTEM: SPIRAL CABLE: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
* w/ Navigation System (for HDD):
* After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Testing and Inspection.
2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

3. REMOVE SWITCH AND VOLUME CASE Removal

4. REMOVE LOWER NO. 2 STEERING WHEEL COVER Removal

5. REMOVE STEERING PAD Removal

6. REMOVE STEERING WHEEL ASSEMBLY Removal

7. REMOVE STEERING COLUMN COVER (w/o Driver Monitor Camera) Removal

8. REMOVE STEERING COLUMN COVER (w/ Driver Monitor Camera) Removal

9. REMOVE SPIRAL CABLE SUB-ASSEMBLY

(a) Disconnect the connectors from the spiral cable with steering angle sensor.





NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Detach the 3 claws and remove the spiral cable with steering angle sensor.

10. REMOVE STEERING SENSOR

(a) Detach the 6 claws and remove the spiral cable.