Removal

2GR-FSE STARTING: ENGINE SWITCH: REMOVAL

1. PRECAUTION (W/ Navigation System for HDD)

NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

4. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH Removal

5. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH Removal

6. REMOVE CONSOLE PANEL SUB-ASSEMBLY Removal

7. REMOVE FRONT ASH RECEPTACLE ASSEMBLY Removal

8. REMOVE REAR ASH RECEPTACLE ASSEMBLY Removal

9. REMOVE CONSOLE BOX REGISTER ASSEMBLY Removal

10. REMOVE CONSOLE BOX Removal

11. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

12. REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL Removal

13. REMOVE INTEGRATION CONTROL PANEL WITH RADIO RECEIVER ASSEMBLY (W/O Navigation System) Removal

14. REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY (W/ Navigation System) Removal

15. REMOVE ENGINE SWITCH

(a) Disconnect the switch connector.





(b) Detach the 2 claws and remove the switch.