Installation
SEAT BELT: REAR SEAT INNER BELT ASSEMBLY: INSTALLATION
1. INSTALL REAR SEAT 3 POINT TYPE INNER BELT ASSEMBLY
(a) Insert the rear seat 3 point type inner belt assembly as shown in the illustration.
(b) Temporarily install the rear seat 3 point type inner belt assembly with the 2 bolts.
(c) Fully tighten the bolt [A] first, then the bolt [B] to install the rear seat 3 point type inner belt assembly.
Bolt A - Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)
Bolt B - Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
2. INSTALL PACKAGE TRAY BRACKET
(a) Install the package tray bracket with the 2 nuts.
3. INSTALL REAR PACKAGE TRAY END PLATE (for LH Side)
(a) Install the rear package tray end plate.
4. INSTALL ROLL OVER GARNISH LH
(a) Engage the 7 claws.
(b) Install the roll over garnish LH with 2 bolts.
(c) Engage the 2 claws and close the tether cover as shown in the illustration.
5. INSTALL ROLL OVER GARNISH RH
HINT
Use the same procedure for the RH side and LH side.
6. INSTALL REAR PACKAGE TRAY END PLATE (for RH Side)
HINT
Use the same procedure for the RH side and LH side.
7. INSTALL FRONT PACKAGE TRAY TRIM BOARD
(a) Pass the anchor part of rear seat 3 point type outer belt assembly through the front package trim board.
(b) Engage the guide, 2 clips and 2 claws.
(c) Install the 2 bolts and front package tray trim board.
(d) Engage the 2 guides.
(e) Engage the 2 claws and install the belt guide to the package tray trim board.
8. INSTALL REAR SEATBACK ASSEMBLY WITH REAR CONSOLE BOX ASSEMBLY Installation
9. CONNECT REAR SEAT 3 POINT TYPE INNER BELT ASSEMBLY LH
(a) Connect the floor anchor end of the rear seat 3 point type outer belt assembly LH and install the bolt.
Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
10. CONNECT REAR SEAT 3 POINT TYPE INNER BELT ASSEMBLY RH
HINT
Use the same procedure for the RH side and LH side.
11. INSTALL REAR SEAT CUSHION ASSEMBLY LH Installation
12. INSTALL REAR SEAT CUSHION ASSEMBLY RH Installation
13. INSTALL PACKAGE TRAY TRIM GARNISH LH Installation
14. INSTALL PACKAGE TRAY TRIM GARNISH RH Installation
15. CLOSE METAL TOP ROOF Installation