Removal

METER / GAUGE / DISPLAY: CLOCK: REMOVAL

1. PRECAUTION

NOTICE:
* After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal Service Precautions.
* When disassembling the clock assembly, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (W/ Navigation System for HDD)

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission) Removal

4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission) Removal

5. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH (for Automatic Transmission) Removal

6. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH (for Automatic Transmission) Removal

7. REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission) Removal

8. REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Removal

9. REMOVE FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Removal

10. REMOVE FRONT ASH RECEPTACLE ASSEMBLY Removal

11. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

12. REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL Removal

13. REMOVE INTEGRATION CONTROL PANEL WITH RADIO RECEIVER ASSEMBLY (W/O Navigation System) Removal

14. REMOVE NO. 1 RADIO BRACKET (W/O Navigation System) Removal

15. REMOVE NO. 2 RADIO BRACKET (W/O Navigation System) Removal

16. REMOVE RADIO RECEIVER ASSEMBLY (W/O Navigation System) Removal

17. REMOVE CLOCK SUB-ASSEMBLY (W/O Navigation System)

(a) Remove the 6 screws.

(b) Disengage the 5 claws and panel.

(d) Disconnect the connector.

(e) Remove the clock sub-assembly.

18. REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY (W/ Navigation System) Removal

19. REMOVE NO. 1 RADIO BRACKET (W/ Navigation System) Removal

20. REMOVE NO. 2 RADIO BRACKET (W/ Navigation System) Removal

21. REMOVE RADIO RECEIVER ASSEMBLY (W/ Navigation System) Removal

22. REMOVE CLOCK ASSEMBLY (W/ Navigation System for DVD)

(a) Apply protective tape to the places shown in the illustration.

Text in Illustration

(b) Insert 2 precision screwdrivers (with a diameter of 1.5 or less) into the holes on both sides of the clock assembly at the angle as shown in the illustration.

NOTICE:
Do not pry on the clock assembly with the screwdrivers as it may damage the clock assembly.

HINT
If precision screwdrivers are not available, use in-vehicle tools (part No. 09135-53010).

(c) Insert a screwdriver from the underside of the hazard switch, and pull and remove the clock assembly.

Text in Illustration

NOTICE:
Do not pry on the hazard switch with the screwdriver as it may damage the switch.

HINT
Tape the screwdriver tip before use.

23. REMOVE CLOCK ASSEMBLY (W/ Navigation System for HDD)

(a) Disengage the 2 clips and remove the clock assembly as shown in the illustration.