Turn Signal Flasher: Testing and Inspection

LIGHTING (EXT): TURN SIGNAL FLASHER ASSEMBLY: INSPECTION

1. INSPECT TURN SIGNAL FLASHER ASSEMBLY

(a) Disconnect the J30 connector.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





(c) If the result is not as specified, there is a malfunction on the wire harness side.

(d) Reconnect the connector.

(e) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





(f) If the result is not as specified, the flasher assembly may have a malfunction.