Removal

4GR-FSE INTAKE / EXHAUST: EXHAUST MANIFOLD: REMOVAL

1. REMOVE ENGINE UNDER COVER

2. REMOVE FRONT FLOOR COVER LH Removal

3. REMOVE FRONT FLOOR COVER RH Removal

4. REMOVE NO. 2 FLOOR UNDER COVER Removal

5. REMOVE NO. 1 FLOOR UNDER COVER Removal

6. REMOVE NO. 1 BODY MOUNTING BRACKET SUB-ASSEMBLY LH Removal

7. REMOVE NO. 1 BODY MOUNTING BRACKET SUB-ASSEMBLY RH Removal

8. REMOVE NO. 2 ENGINE UNDER COVER

9. REMOVE REAR BODY SUPPORT BRACKET

(a) Remove the 12 bolts and 2 rear body support brackets.





10. REMOVE FRONT CENTER FLOOR BRACE

(a) Remove the 6 bolts and front center floor brace.





11. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal

12. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY (for Automatic Transmission)

(a) Remove the 2 bolts and No. 1 exhaust pipe support bracket sub-assembly.





13. REMOVE COOL AIR INTAKE DUCT SEAL Removal

14. REMOVE ENGINE ROOM SIDE COVER Removal

15. REMOVE ENGINE ROOM SIDE COVER LH Removal

16. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

17. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE Removal

18. REMOVE POWER STEERING ECU ASSEMBLY

(a) Remove the power steering ECU assembly Removal.

19. REMOVE BATTERY TRAY Removal

20. REMOVE NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE Removal

21. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) Removal

22. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

(a) Remove the 6 nuts, exhaust manifold sub-assembly RH and gasket.





23. SEPARATE NO. 3 ENGINE ROOM RELAY BLOCK

(a) Remove the 2 bolts and earth wire.





(b) Remove the bolt, nut and separate the No. 3 engine room relay block.





24. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

(a) Disconnect the air fuel ratio sensor connector (for Bank 2 Sensor 1).

(b) Remove the 6 nuts, exhaust manifold sub-assembly LH and gasket.





25. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) Removal