Replacement
RA62 MANUAL TRANSMISSION: MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL: REPLACEMENT
1. REMOVE REAR NO. 1 FLOOR PANEL BRACE Removal
2. REMOVE FRONT CENTER FLOOR BRACE Removal
3. DISCONNECT HEATED OXYGEN SENSOR Removal
4. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal
5. DRAIN MANUAL TRANSMISSION OIL
(a) Remove the drain plug and gasket, and drain the transmission oil.
(b) Install a new gasket and the drain plug.
Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)
6. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR Removal
7. REMOVE OUTSIDE AIR GUIDE PLATE RH Removal
8. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY Removal
9. REMOVE MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL
(a) Using SST, remove the oil seal.
SST : 09308-00010
10. INSTALL MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL
(a) Using SST and a hammer, install a new oil seal to the extension housing.
SST : 09325-20010
Installation depth:
- 0.5 to 0.5 mm (-0.020 to 0.020 in.)
(b) Coat the lip of the oil seal with MP grease.
11. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY Installation
12. INSPECT AND ADJUST NO. 2 AND NO. 3 JOINT ANGLE Installation
13. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR Installation
14. INSTALL OUTSIDE AIR GUIDE PLATE RH Installation
15. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation
16. INSTALL HEATED OXYGEN SENSOR Installation
17. INSTALL FRONT CENTER FLOOR BRACE Installation
18. INSTALL REAR NO. 1 FLOOR PANEL BRACE Installation
19. ADD MANUAL TRANSMISSION OIL
(a) Park the vehicle in a level place.
(b) Remove the transmission filler plug and gasket.
(c) Check that the oil surface is within 5 mm (0.20 in.) below the lowest point of the transmission filler plug opening.
Oil grade:
API GL-5
Viscosity:
SAE 75W-90
NOTICE:
* Problems may occur when the oil level is too high or too low.
* After replacing the oil, drive the vehicle and check the oil level again.
(d) Check for oil leakage if the oil level is low.
(e) Install the transmission filler plug and a new gasket.
Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)
20. CHECK FOR EXHAUST GAS LEAKS Installation
21. INSPECT AND ADJUST MANUAL TRANSMISSION OIL LEVEL Testing and Inspection