Brake Lamp Relay: Testing and Inspection

LIGHTING: STOP LIGHT CONTROL RELAY: INSPECTION

1. INSPECT STOP LIGHT CONTROL RELAY

(a) Disconnect the J89 stop light control relay connector.





(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:





(c) If the result is not as specified, there is a malfunction on the wire harness side.

(d) Measure the resistance according to the value(s) in the table below.

Standard resistance:





(e) If the result is not as specified, there is a malfunction on the wire harness side.

(f) Reconnect the J89 stop light control relay connector.





(g) Measure the voltage according to the value(s) in the table below.

Standard voltage:





(h) If the result is not as specified, replace the stop light control relay.