Removal

OTHER SYSTEM: CLOCK: REMOVAL

NOTICE:
* After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
* When disassembling the clock assembly, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.
1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission) Removal

2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission) Removal

3. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH (for Automatic Transmission) Removal

4. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH (for Automatic Transmission) Removal

5. REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission) Removal

6. REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Removal

7. REMOVE FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Removal

8. REMOVE FRONT ASH RECEPTACLE SUB-ASSEMBLY Removal

9. REMOVE CONSOLE BOX REGISTER ASSEMBLY Removal

10. REMOVE CONSOLE BOX Removal

11. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

12. REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL Removal

13. REMOVE INTEGRATION CONTROL PANEL WITH RADIO RECEIVER ASSEMBLY (w/o Navigation System) Removal

14. REMOVE NO. 1 RADIO BRACKET (w/o Navigation System) Removal

15. REMOVE NO. 2 RADIO BRACKET (w/o Navigation System) Removal

16. REMOVE RADIO RECEIVER ASSEMBLY (w/o Navigation System) Removal

17. REMOVE CLOCK ASSEMBLY (w/o Navigation System)

(a) Remove the 6 screws.

(b) Disengage the 5 claws and integration control panel.

(d) Disconnect the connectors.

(e) Remove the clock assembly.

18. REMOVE MULTI-DISPLAY ASSEMBLY (w/ Navigation System) Removal

19. REMOVE NO. 1 RADIO BRACKET (w/ Navigation System) Removal

20. REMOVE NO. 2 RADIO BRACKET (w/ Navigation System) Removal

21. REMOVE RADIO RECEIVER ASSEMBLY (w/ Navigation System) Removal

22. REMOVE CLOCK ASSEMBLY (w/ Navigation System for DVD)

(a) Apply protective tape to the places shown in the illustration.

(b) Insert 2 precision screwdrivers (with a diameter of 1.5 mm or less) into the holes on both sides of the clock assembly at the angle as shown in the illustration.

NOTICE:
Do not pry on the clock assembly with the screwdrivers as it may damage the clock assembly.

HINT
If precision screwdrivers are not available, use in-vehicle tools (part No. 09135-53010).

(c) Pull and remove the clock assembly.

23. REMOVE CLOCK ASSEMBLY (w/ Navigation System for HDD)

(a) Disengage the 2 clips and remove the clock assembly as shown in the illustration.