Removal

AIR CONDITIONING: CONDENSER: REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL Removal

2. REMOVE SIDE ENGINE ROOM COVER LH Removal

3. REMOVE SIDE ENGINE ROOM COVER RH Removal

4. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

5. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM

(a) Start up the engine.

(b) Turn the A/C switch on.

(c) Operate the cooler compressor at an engine rpm of approximately 1,000 for 5 to 6 minutes to circulate the refrigerant and collect compressor oil remaining in each component into the cooler compressor as much as possible.

(d) Stop the engine.

(e) Using SST, let the refrigerant gas out.

SST : 09985-20010

09985-02010

09985-02050

09985-02060

09985-02070

09985-02080

09985-02090

09985-02110

09985-02130

09985-02140

09985-02150

6. REMOVE NO. 1 INLET AIR CLEANER Removal

7. REMOVE UNDER ENGINE COVER

8. REMOVE FRONT BUMPER ASSEMBLY Removal

9. REMOVE FRONT BUMPER ENERGY ABSORBER

10. REMOVE RADIATOR SUPPORT OPENING COVER Removal

11. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) Removal

12. REMOVE HOOD LOCK CONTROL CABLE COVER Removal

13. DISCONNECT HOOD LOCK ASSEMBLY Removal

14. REMOVE RADIATOR SUPPORT UPPER Removal

15. DISCONNECT LIQUID TUBE SUB-ASSEMBLY

(a) Remove the 2 bolts and disconnect the liquid tube sub-assembly from the cooler condenser assembly.

(b) Remove the O-ring from the liquid tube sub-assembly.

NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.

16. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

(a) Remove the bolt and disconnect the discharge hose sub-assembly from the cooler condenser assembly.

(b) Remove the O-ring from the discharge hose sub-assembly.

NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.

17. REMOVE COOLER CONDENSER ASSEMBLY

(a) Remove the 4 bolts and cooler condenser assembly.

18. REMOVE COOLER DRYER

(a) Using a straight hexagon wrench 14 mm, remove the cap from the modulator.

(b) Using pliers, remove the cooler dryer.