Removal

PARKING BRAKE: PARKING BRAKE LEVER: REMOVAL

1. PRECAUTION

CAUTION:
Be sure to read the "PRECAUTION" thoroughly before servicing Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. REMOVE FRONT SEAT ASSEMBLY (for Standard Type Power Seat)

HINT
Removal

4. REMOVE FRONT SEAT ASSEMBLY (for Sports Type Power Seat)

HINT
Removal

5. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

HINT
Removal

6. REMOVE REAR SEAT CUSHION ASSEMBLY Removal

7. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

Removal

8. REMOVE FRONT DOOR SCUFF PLATE LH Removal

9. REMOVE REAR DOOR SCUFF PLATE LH Removal

10. REMOVE CENTER PILLAR GARNISH LOWER LH Removal

11. REMOVE FRONT DOOR OPENING TRIM COVER LH Removal

12. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

13. REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY Removal

14. REMOVE FRONT CONSOLE PANEL SUB-ASSEMBLY Removal

15. REMOVE FRONT ASH RECEPTACLE SUB-ASSEMBLY Removal

16. REMOVE CONSOLE BOX REGISTER ASSEMBLY Removal

17. REMOVE CONSOLE BOX Removal

18. REMOVE CENTER AIRBAG SENSOR ASSEMBLY Removal

19. REMOVE FRONT FLOOR REAR UPPER SUB PANEL SUB-ASSEMBLY

(a) Turn back the floor carpet in order to remove the front floor rear upper sub panel.

(b) Disengage the 6 clamps.

(c) Remove the 4 bolts and front floor rear upper sub panel.

20. REMOVE FLOOR PANEL BRACE REAR NO.1 Removal

21. REMOVE FRONT CENTER FLOOR BRACE Removal

22. DISCONNECT OXYGEN SENSOR Removal

23. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal

24. REMOVE NO. 1 FRONT FLOOR HEAT INSULATOR Removal

25. REMOVE AIR GUIDE PLATE OUTSIDE RH Removal

26. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY Removal

27. REMOVE PARKING BRAKE LEVER SUB-ASSEMBLY

(a) Using needle-nose pliers, remove the parking brake return with damper spring.

(b) Remove the 2 bolts and separate the 2 No. 2 parking brake cable assemblies from the parking brake equalizer.

(d) Remove the parking brake equalizer from the No. 1 parking brake cable assembly.

(e) Remove the 2 bolts and separate the No.1parking brake cable assembly.

(f) Disconnect the parking brake switch connector.

(g) Remove the 2 bolts and parking brake lever.

(h) Pull up the parking brake lever claw.

(i) Remove the lock nut and No. 1 wire adjusting nut of the No. 1 parking brake cable assembly from the parking brake lever.

(j) Remove the clip and No. 1 parking brake cable assembly from the parking brake lever.