Installation

2GR-FSE FUEL: FUEL PRESSURE PULSATION DAMPER: INSTALLATION

1. INSTALL FUEL PRESSURE PULSATION DAMPER

(a) Temporarily install 2 new gaskets, the fuel tube and the fuel pressure pulsation damper to the fuel pump.

(b) Using SST, tighten the fuel pressure pulsation damper.





SST : 09612-24014

09617-24011

without SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

with SST - Torque : 35 Nm (357 kgf-cm, 26 ft-lbf)

HINT
* Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
* Make sure SST and wrench are connected in a straight line.
2. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE Installation

3. CONNECT NO. 2 VENTILATION HOSE Installation

4. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation

5. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation

6. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation

7. INSTALL FRONT FENDER TO COWL SIDE SEAL LH Installation

8. INSTALL FRONT FENDER TO COWL SIDE SEAL RH Installation

9. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH Installation

10. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH Installation

11. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

12. INSTALL ENGINE ROOM SIDE COVER RH Installation

13. INSTALL ENGINE ROOM SIDE COVER LH Installation

14. INSTALL COOL AIR INTAKE DUCT SEAL Installation

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

16. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.