Slip Indicator Light Remains ON

BRAKE CONTROL: ELECTRONICALLY CONTROLLED BRAKE SYSTEM: Slip Indicator Light Remains ON
- Slip Indicator Light Remains ON

DESCRIPTION

The skid control ECU is connected to the combination meter via the CAN and multiplex communication systems.

If the skid control ECU stores a DTC, the SLIP indicator light will come on in the combination meter.

The SLIP indicator blinks during VSC and/or TRAC operation.

When the system fails, the SLIP indicator comes on to warn the driver.

WIRING DIAGRAM







NOTICE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration Initialization.

PROCEDURE

1. INSPECT CAN COMMUNICATION SYSTEM

(a) Check if the CAN communication system DTC is output Diagnosis System.

Result:





B -- REPAIR CAN COMMUNICATION SYSTEM
A -- Continue to next step.

2. INSPECT MULTIPLEX COMMUNICATION SYSTEM

(a) Check if the multiplex communication system DTC is output Reading and Clearing Diagnostic Trouble Codes.

Result:





B -- REPAIR MULTIPLEX COMMUNICATION SYSTEM
A -- Continue to next step.

3. INSPECT IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED

(a) Check the skid control ECU connector's connection.

OK:

The connector is securely connected.

NG -- CONNECT CONNECTOR TO ECU CORRECTLY
OK -- Continue to next step.

4. INSPECT BATTERY

(a) Check the battery voltage.

Voltage:

11 to 14 V

NG -- INSPECT CHARGING SYSTEM
OK -- Continue to next step.

5. INSPECT COMBINATION METER ASSEMBLY

(a) Check the combination meter assembly Problem Symptoms Table.

HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part Problem Symptoms Table.

NG -- REPLACE COMBINATION METER ASSEMBLY

OK -- REPLACE SKID CONTROL ECU