B2006

PRE-COLLISION: PRE-COLLISION SYSTEM: B2006: Short to GND in Seat Belt Motor LH Circuit
B2006 - Short to GND in Seat Belt Motor LH Circuit

DESCRIPTION

The seat belt control ECU receives information from the distance control ECU using CAN communication and tightens the seat belt by operating the motor in the front seat outer belt assembly LH.

CAUTION:
The pretensioner is built into the front seat outer belt assembly LH. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may activate the pretensioner.





WIRING DIAGRAM

B2005

INSPECTION PROCEDURE

NOTICE:
When the seat belt control ECU is replaced with a new one, Initialization must be performed Pre-Collision System.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY LH - SEAT BELT CONTROL ECU)

(a) Disconnect the cable from the negative (-) battery terminal.





CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(b) Disconnect the seat belt control ECU connector and front seat outer belt assembly LH connector.

(c) Connect the cable to the negative (-) battery terminal.

(d) Measure the resistance according to the value(s) in the table below.

Standard resistance:





(e) Reconnect the front seat outer belt assembly LH connector and seat belt control ECU connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. CHECK FRONT SEAT OUTER BELT ASSEMBLY LH

(a) Disconnect the front seat outer belt assembly LH connector.





(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:





(c) Reconnect the front seat outer belt assembly LH connector.

NG -- REPLACE FRONT SEAT OUTER BELT ASSEMBLY LH

OK -- REPLACE SEAT BELT CONTROL ECU