B2002

PRE-COLLISION: PRE-COLLISION SYSTEM: B2002: Open in Seat Belt Motor RH Circuit
B2002 - Open in Seat Belt Motor RH Circuit

DESCRIPTION

The seat belt control ECU receives information from the distance control ECU using CAN communication and tightens the seat by operating the motor in the front seat outer belt assembly RH.

CAUTION:
The pretension is built into the front seat outer belt assembly RH. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may activate the pretension.

WIRING DIAGRAM

B2000

INSPECTION PROCEDURE

NOTICE:
When the seat belt control ECU is replaced with a new one, Initialization must be performed Pre-Collision System.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY RH - SEAT BELT CONTROL ECU)

(a) Disconnect the cable from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(b) Disconnect the seat belt control ECU connector and front seat outer belt assembly RH connector.

(c) Connect the cable to the negative (-) battery terminal.

(d) Using a service wire, connect U8-1 and U8-2 of the connector on the front seat outer belt assembly RH side.

NOTICE:
Do not forcibly insert a service wire into the terminals of a connector.

(e) Measure the resistance according to the value(s) in the table below.

Standard resistance:

(f) Reconnect the front seat outer belt assembly RH connector and seat belt control ECU connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. CHECK FRONT SEAT OUTER BELT ASSEMBLY RH

(a) Disconnect the front seat outer belt assembly RH connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

(c) Reconnect the front seat outer belt assembly RH connector.

NG -- REPLACE FRONT SEAT OUTER BELT ASSEMBLY RH

OK -- REPLACE SEAT BELT CONTROL ECU