Installation

SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSTALLATION

1. INSTALL FRONT SEAT OUTER BELT ASSEMBLY

(a) Check the degree of tilt when the ELR begins to lock.





(1) Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the belt.

NOTICE:
Do not disassemble the retractor.

(b) Temporarily install the front seat outer belt assembly with the 2 bolts.





(c) Fully tighten the upper side bolt first, then the lower side bolt to install the front seat outer belt assembly.

for Upper bolt - Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)

for Lower bolt - Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

(d) Connect the pretensioner connector and lock the locking button as shown in the illustration.





NOTICE:
Securely lock the locking button.

(e) Connect the connectors.

2. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

(a) Install the front shoulder belt anchor adjuster assembly with the 2 bolts.





Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

3. CONNECT FRONT SEAT OUTER BELT ASSEMBLY

(a) Install the shoulder anchor of the front seat outer belt assembly with the nut.





Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

4. INSTALL UPPER CENTER PILLAR GARNISH Installation

5. INSTALL LOWER CENTER PILLAR GARNISH Installation

6. INSTALL REAR DOOR SCUFF PLATE Installation

7. INSTALL FRONT DOOR SCUFF PLATE Installation

8. CONNECT FRONT SEAT OUTER BELT ASSEMBLY

(a) for Driver seat:





(1) Install the floor end of the front seat outer belt assembly with the bolt.

Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

(b) for Passenger seat:





(1) Install the floor end of the front seat outer belt assembly with the bolt.

Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

(2) Connect the connector.





CAUTION:
* Set the wire as shown in the illustration.
* Do not apply excessive force when setting the wire.
(c) Check if the ELR locks.

NOTICE:
The check should be performed with the outer belt assembly installed.

(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.

9. INSTALL SEAT BELT ANCHOR COVER CAP

(a) Engage the 7 claws to install the seat belt anchor cover cap.





10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

11. PERFORM INITIALIZATION

NOTICE:
Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization.

12. INSPECT SRS WARNING LIGHT

Diagnosis System