Installation

SUPPLEMENTAL RESTRAINT SYSTEM: DRIVER SIDE KNEE AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

(a) Check that the engine switch is off.

(b) Check that the battery negative (-) cable is disconnected.

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

(c) Temporarily install the driver side knee airbag assembly with the 2 hooks.





(d) Engage the 2 claws and install the DLC3.





(e) Install the driver side knee airbag assembly with the 4 bolts.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(f) Connect the driver side knee airbag connector.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation

3. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

4. INSTALL SIDE INSTRUMENT PANEL LH Installation

5. INSTALL FRONT DOOR OPENING TRIM COVER LH Installation

6. INSTALL FRONT DOOR SCUFF PLATE LH Installation

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

8. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

HINT
Some systems need initialization after reconnecting the cable to the negative battery terminal.

9. INSPECT DRIVER SIDE KNEE AIRBAG ASSEMBLY Driver Side Knee Airbag Assembly

10. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.