Removal

SUSPENSION: REAR STABILIZER BAR: REMOVAL

REMOVAL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. REMOVE WHEEL HUB ORNAMENT SUB-ASSEMBLY
(a) Remove the 10 bolts and ornament.
2. REMOVE REAR WHEEL
(a) Remove the 5 nuts and wheel.





3. REMOVE REAR STABILIZER LINK ASSEMBLY LH
(a) Remove the bolt and nut from the rear No. 2 suspension arm.
(b) Remove the nut and stabilizer link from the stabilizer bar.
4. REMOVE REAR STABILIZER BAR





(a) Remove the 4 bolts and 4 nuts, and disconnect the exhaust pipe.
(b) Remove the 8 bolts and rear end body mounting set plate.





(c) Remove the 4 bolts and 2 stabilizer bar brackets and stabilizer bar from the suspension member.
(d) Remove the 2 bushes from the stabilizer bar.