Installation

SUSPENSION: REAR NO. 1 SUSPENSION ARM: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
(a) Temporarily install the suspension arm with the 2 bolts and 2 nuts.
HINT: After stabilizing the suspension, tighten the nuts.

2. INSTALL REAR WHEEL
(a) Install the wheel with the 5 nuts.
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
3. STABILIZE SUSPENSION Installation
4. TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
(a) Tighten the 2 bolt and 2 nuts.
Torque: 75 Nm (765 kgf-cm, 55 ft-lbf)
5. INSTALL WHEEL HUB ORNAMENT SUB-ASSEMBLY
(a) Install the ornament with the 10 bolts.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)