Removal

POWER STEERING: VANE PUMP: REMOVAL

REMOVAL

1. DRAIN POWER STEERING FLUID
2. REMOVE ENGINE UNDER COVER
(a) Remove the 16 screws and under cover.
3. REMOVE ENGINE UNDER COVER REAR RH
(a) Remove the 2 bolts and under cover.
4. REMOVE NO. 1 AIR CLEANER INLET
(a) Remove the bolt and No. 1 air cleaner inlet.
5. REMOVE AIR CLEANER ASSEMBLY
(a) Disconnect the MAF meter connector.
(b) Remove the clamp.
(c) Remove the 3 bolts and air cleaner.





6. REMOVE FAN AND GENERATOR V BELT
(a) Set a wrench on the drive belt tensioner set bolt.
(b) Turn the drive belt tensioner set bolt counterclockwise and hold it.
HINT: The drive belt tensioner set bolt has a left-hand thread. The drive belt tensioner set bolt loosens when it is turned clockwise.

(c) Remove the fan and generator V belt.
(d) Release the drive belt tensioner.
7. REMOVE VANE PUMP ASSEMBLY
(a) Remove the return hose, 2 vacuum hoses and 3 clips.
(b) Remove the pressure feed hose union bolt, pressure feed tube and gasket.
(c) Remove the 2 bolts, nut and vane pump.