Removal

SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL

REMOVAL
CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it Service Precautions.

1. SHIP MODE SETTING
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

3. REMOVE DOOR SCUFF PLATE ASSEMBLY LH Removal
4. REMOVE FRONT DOOR OPENING TRIM COVER LH
5. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Removal
6. REMOVE CONSOLE UPPER PANEL GARNISH REAR Removal
7. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal
8. REMOVE AIR CONDITIONING CONTROL ASSEMBLY Removal
9. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY LOWER CENTER
10. SHIP MODE CONFIRMATION
11. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal
12. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal
13. REMOVE CONSOLE BOX CARPET
14. REMOVE NO. 3 BOX PANEL Removal
15. REMOVE CONSOLE BOX ASSEMBLY Removal
16. REMOVE TIRE PRESSURE MONITOR RECEIVER ASSEMBLY
17. REMOVE CENTER AIRBAG SENSOR ASSEMBLY





(a) Remove the 3 clamps from the airbag sensor.
(b) Disconnect the 3 airbag sensor connectors.
(c) Remove the 3 bolts and airbag sensor.