P0230

3UZ-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P0230: Fuel Pump Primary Circuit

DTC P0230 - Fuel Pump Primary Circuit

DESCRIPTION

When the engine is cranked, current flows from terminal ST2 of the ignition switch to the starter relay coil and also current flows to terminal STA of the ECM (STA signal). When the STA signal and NE signal are input to the ECM, Transistor 1 (Tr1) of the ECM is turned ON, current flows to the coil of the circuit opening relay (Marking CIR OPN), the relay switches on, power is supplied to the fuel pump, and the fuel pump operates. While the NE signal is generated (engine running), the ECM keeps Tr1 ON (circuit opening relay ON) and the fuel pump also keeps operating. The fuel pump speed is controlled at two levels (high speed or low speed) by the condition of the engine (starting, light load, heavy load). The fuel pump operates at high speed when: 1) the engine starts and the STA signal is ON; and 2) Transistor 2 (Tr2) of the ECM is OFF, causing the fuel pump relay (Marking: F/PMP) to close and battery positive voltage to be applied directly to the fuel pump. The fuel pump operates at low speed when: 1) after the engine starts, the engine is idling or has a light load; and 2) since the ECM's Tr2 is ON, battery positive voltage is applied to the fuel pump via the fuel pump resistor.









WIRING DIAGRAM





INSPECTION PROCEDURE
HINT: This troubleshooting procedure is based on the premise that the engine is started. If the engine is not started, proceed to the problem symptoms table Symptom Related Diagnostic Procedures.

PROCEDURE

1. CHECK ECM (FPR VOLTAGE)




(a) Measure the voltage of the ECM connectors.
Standard voltage:






NG -- REPLACE ECM
OK -- Continue to next step.
2. INSPECT FUEL PUMP RELAY (Marking: F/PMP)




(a) Remove the fuel pump relay from the engine room No. 2 relay block.
(b) Measure the resistance of the fuel pump relay.
Standard resistance:






NG -- REPLACE FUEL PUMP RELAY
OK -- Continue to next step.
3. CHECK WIRE HARNESS (FUEL PUMP RELAY (Marking: F/PMP) - ECM)




(a) Remove the fuel pump relay from the engine room No. 2 relay block.
(b) Disconnect the E6 ECM connector.
(c) Measure the resistance of the wire harness side connectors.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS AND CONNECTOR
OK -- REPLACE ECM