B2502

CONVERTIBLE: RETRACTABLE HARDTOP SYSTEM: B2502: Open in Roof Drive Motor RH Circuit

DTC B2502 - Open in Roof Drive Motor RH Circuit

DESCRIPTION

With the roof control switch being pressed, the sliding roof control ECU operates the roof panel, luggage door and package tray (in that order).
The ECU operates the roof panel while adjusting the speed of the left and right motors.






WIRING DIAGRAM





INSPECTION PROCEDURE
HINT: Continuously repeating the roof open/close operation may stop the motor operation due to a function of the positive temperature coefficient thermistor. However, this is not a malfunction.

PROCEDURE

1. INSPECT FUSE (ROOF RH)
(a) Remove the ROOF RH fuse from the luggage room junction block.
(b) Measure the resistance of the fuse.
Standard resistance:
Below 1 Ohms
NG -- REPLACE FUSE
OK -- Continue to next step.
2. INSPECT SLIDING ROOF DRIVE GEAR ASSEMBLY RH (ROOF DRIVE MOTOR RH)




(a) Remove the sliding roof drive gear RH Removal.
(b) Apply battery voltage to the drive gear terminals and check operation of the sliding roof drive gear RH.
OK:






NG -- REPLACE SLIDING ROOF DRIVE GEAR ASSEMBLY RH
OK -- Continue to next step.
3. CHECK WIRE HARNESS FOR OPEN CIRCUIT (ECU - SLIDING ROOF DRIVE GEAR RH)




(a) Disconnect the S20 ECU connector.
(b) Disconnect the R17 drive gear connector.
(c) Measure the resistance of the wire harness side connectors.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS AND CONNECTOR
OK -- REPLACE SLIDING ROOF CONTROL ECU