Installation

SUSPENSION: FRONT STABILIZER BAR (for 2WD): INSTALLATION

INSTALLATION
HINT: A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH





(a) Install the front suspension member reinforcement LH to the vehicle with the 4 bolts.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)
2. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH
HINT: Install the RH side following the same procedures as the LH side.

3. INSTALL FRONT NO. 1 STABILIZER BAR BUSH





(a) Install the 2 front No. 1 stabilizer bar bushes outside of the bush stoppers on the front stabilizer bar as shown in the illustration.
NOTE:
Be sure to install the front No. 1 stabilizer bar bushes so that the cutouts face the front of the vehicle.

4. TEMPORARILY TIGHTEN FRONT STABILIZER BAR





(a) Temporarily install the front stabilizer bar with the 4 bolts and the front No. 1 stabilizer bracket LH and RH.
NOTE:
Install the front stabilizer bar so that the identification mark face vehicle right side.

5. TIGHTEN FRONT NO. 1 STABILIZER BRACKET LH





(a) Tighten the front No. 1 stabilizer bracket LH with the 2 bolts.
Torque: 49 Nm (500 kgf-cm, 36 ft-lbf)
6. TIGHTEN FRONT NO. 1 STABILIZER BRACKET RH
HINT: Install the RH side following the same procedures as the LH side.

7. INSTALL ENGINE UNDER COVER REAR LH





(a) Install the engine under cover rear LH with the 2 screws.
8. INSTALL ENGINE UNDER COVER REAR RH
HINT: Install the RH side following the same procedures as the LH side.

9. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY LH





(a) Install the engine under cover sub-assembly LH with the 2 screws.
10. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY RH
HINT: Install the RH side following the same procedures as the LH side.

11. INSTALL FRONT STABILIZER LINK ASSEMBLY LH





(a) Install the front stabilizer link with the 2 nuts.
Torque: 84 Nm (857 kgf-cm, 62 ft-lbf)
HINT: If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.

12. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT: Install the RH side following the same procedures as the LH side.

13. INSTALL NO. 2 ENGINE UNDER COVER





(a) Install the No. 2 engine under cover with the 8 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
Torque: 27 Nm (275 kgf-cm, 20 ft-lbf)
14. INSTALL FRONT WHEEL
15. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT Installation
16. VEHICLE PREPARATION FOR HEADLIGHT AIMING ADJUSTMENT Adjustments
17. PREPARATION FOR HEADLIGHT AIMING (Using a screen) Adjustments
18. HEADLIGHT AIMING INSPECTION Adjustments
19. HEADLIGHT AIMING ADJUSTMENT Adjustments