Removal

SUSPENSION: FRONT STABILIZER BAR (for AWD): REMOVAL

REMOVAL

1. REMOVE FRONT CENTER FLOOR COVER Removal
2. REMOVE NO. 2 ENGINE UNDER COVER Removal
3. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH Removal
4. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH Removal
5. REMOVE NO. 1 ENGINE UNDER COVER Service and Repair
6. REMOVE FRONT LOWER SUSPENSION MEMBER PROTECTOR Removal
7. REMOVE FRONT STABILIZER LINK ASSEMBLY LH





(a) Remove the 2 nuts and front stabilizer link.
HINT: If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.

8. REMOVE FRONT STABILIZER LINK ASSEMBLY RH
HINT: Remove the RH side following the same procedures as the LH side.

9. REMOVE FRONT NO. 1 STABILIZER BRACKET LH
(a) Remove the bolt and wire harness bracket.





(b) Remove the 2 bolts and front No. 1 stabilizer bracket LH from the front frame assembly.
10. REMOVE FRONT NO. 1 STABILIZER BRACKET RH





(a) Remove the 2 bolts and the front No. 1 stabilizer bracket RH from the front frame assembly.
11. REMOVE FRONT STABILIZER BAR
(a) Remove the front stabilizer bar from the vehicle.
12. REMOVE FRONT NO. 1 STABILIZER BAR BUSH
(a) Remove the 2 front No. 1 stabilizer bar bushes from the front stabilizer bar.