Clock Power Source Circuit

OTHER SYSTEM: CLOCK SYSTEM (W/ Multi-display): Clock Power Source Circuit

Clock Power Source Circuit

DESCRIPTION

The circuit provides power to the clock.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. INSPECT FUSE (P-ACC, DOME)
(a) Disconnect the DOME fuse from the main body ECU.
(b) Disconnect the P-ACC fuse from the passenger side junction block.
(c) Measure the resistance of the fuses.
Standard resistance:






NG -- REPLACE FUSE
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (CLOCK - BATTERY AND BODY GROUND)




(a) Disconnect the L38 clock connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:





(c) Measure the voltage according to the value(s) in the table below.
Standard voltage:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE CLOCK ASSEMBLY