Removal

AIR CONDITIONING: INTEGRATION CONTROL AND PANEL (for Front Side): REMOVAL

REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal
4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal
5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal
6. REMOVE NO. 3 BOX PANEL Removal
7. REMOVE REAR CONSOLE PANEL UPPER Removal
8. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER Removal
9. REMOVE RADIO RECEIVER ASSEMBLY Removal
10. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY WITH BRACKET





(a) Remove the 2 bolts.





(b) Pull the panel to detach the 6 clips on the backside of the panel.
(c) Disconnect the connectors and remove the panel.





11. REMOVE NO. 2 RADIO BRACKET
(a) Remove the 2 bolts and bracket.





12. REMOVE NO. 1 RADIO BRACKET
(a) Remove the 2 bolts and bracket.