Removal

AUDIO / VISUAL: INSTRUMENT PANEL SPEAKER: REMOVAL

REMOVAL
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.





3. REMOVE NO. 1 SPEAKER HOLE COVER
(a) Using a screwdriver, detach the 4 clips and remove the hole cover.
HINT: Tape the screwdriver tip before use.

4. REMOVE FRONT NO. 3 SPEAKER ASSEMBLY
(a) Remove the 2 bolts.
(b) Remove the speaker and disconnect the speaker connector.
NOTE:
Do not touch the cone part of the speaker.





5. REMOVE FRONT PILLAR GARNISH LH Removal





6. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
(a) Using a screwdriver, detach the 2 clips and 7 claws.
HINT: Tape the screwdriver tip before use.

(b) Remove the speaker panel.
7. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY
(a) Remove the 2 bolts.
(b) Remove the speaker and disconnect the speaker connector.
NOTE:
Do not touch the cone part of the speaker.