Rear Seat Control Switch Power Source Circuit

NAVIGATION: NAVIGATION SYSTEM (for HDD): Rear Seat Control Switch Power Source Circuit

Rear Seat Control Switch Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the rear power seat module switch.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. INSPECT FUSE (RR MPX-B 2)
(a) Disconnect the RR MPX-B 2 fuse from the luggage room junction block.
(b) Measure the resistance of the fuse.
Standard resistance:

NG -- REPLACE FUSE
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (REAR POWER SEAT MODULE SWITCH - BATTERY AND BODY GROUND)

(a) Disconnect the S15 or r2 switch connector.
(b) Measure the resistance of according to the value(s) in the table below.
Standard resistance:
W/ Ottoman

W/O Ottoman

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE