Removal

NAVIGATION: DISPLAY AND NAVIGATION ASSEMBLY: REMOVAL

REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal
4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal
5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal
6. REMOVE NO. 3 BOX PANEL Removal
7. REMOVE REAR CONSOLE PANEL UPPER Removal
8. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER Removal
9. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET Removal
10. REMOVE DISPLAY AND NAVIGATION ASSEMBLY WITH BRACKET

(a) Remove the 2 bolts.
(b) Pull the multi-display to detach the 6 clips on the backside of the multi-display.

11. REMOVE NO. 2 RADIO BRACKET
(a) Remove the 2 bolts and bracket.

12. REMOVE NO. 1 RADIO BRACKET
(a) Remove the 2 bolts and bracket.