Initialization

PARK ASSIST / MONITORING: ADVANCED PARKING GUIDANCE SYSTEM: INITIALIZATION

INITIALIZATION
HINT:
- If the following operations are performed "SYSTEM INITIALIZING" is displayed on the multi-display. Also, when the expected course lines not displayed the parking guidelines are displayed, pressing the parking assist mode switch and parallel parking assist mode switch causes the message "! System cannot guide under current conditions." to be displayed.





- Move the vehicle to a level area.
- Perform either of the following initialization procedures.

1. Initialization with diagnosis system
(a) Start the diagnostic system Advanced Parking Guidance System.
(b) Perform STEERING CENTER MEMORIZE and MAX STEERING ANGLE MEMORIZE on the STEERING ANGLE SETTING screen Calibration.
(c) Finish the diagnostic system Advanced Parking Guidance System.
2. Initialization with manual operation
(a) Turn the engine switch on (IG) or start the engine.
(b) Fully turn the steering wheel to the right.*
(c) Fully turn the steering wheel to the left.*
HINT: *: These procedures can be performed as shown or in reverse.