Cellular Phone cannot Send/Receive

NAVIGATION: NAVIGATION SYSTEM: Cellular Phone cannot Send/Receive

Cellular Phone cannot Send/Receive

INSPECTION PROCEDURE

PROCEDURE

1. CHECK BLUETOOTH SETTINGS
(a) Check if the Bluetooth settings are correct.
OK:
Bluetooth settings are correct.
NG -- SET SETTINGS CORRECTLY
OK -- Continue to next step.
2. CHECK CELLULAR PHONE
(a) Check if the cellular phone is Bluetooth compatible.
HINT:
Some versions of Bluetooth compatible cellular phones may not function.

OK:
Phone is Bluetooth compatible.
NG -- END (ONLY A BLUETOOTH COMPATIBLE CELLULAR PHONE CAN BE USED)
OK -- Continue to next step.
3. CHECK SETTINGS
(a) Check if the cellular phone functions.
HINT:
The cellular phone is unable to call under any of the following conditions.
- The cellular phone is locked.
- The directory is being transferred.
- The line is crossed.
- Transmission is regulated.
- The power is off.
- The cellular phone is not connected to Bluetooth ("BT" is displayed while connected).
OK:
None of the above conditions exist.

NG -- SET SETTINGS CORRECTLY
OK -- Continue to next step.
4. CHECK CELLULAR PHONE
(a) Check if the cellular phone can make a call.
HINT:
When the battery is low, calls cannot be made or received.

OK:
Cellular phone can make a call.
NG -- REPAIR OR REPLACE CELLULAR PHONE
OK -- Continue to next step.
5. CHECK RECEPTION
(a) Set the cellular phone so that it can receive calls.
(b) Place the cellular phone close to the multi-display.
(c) Check if the cellular phone has reception according to the multi-display.
OK:
Cellular phone has reception.
NG -- REPLACE MULTI-DISPLAY
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE