Removal

SUPPLEMENTAL RESTRAINT SYSTEM: CURTAIN SHIELD AIRBAG ASSEMBLY: REMOVAL

REMOVAL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. PRECAUTION
CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

3. REMOVE ROOF HEADLINING ASSEMBLY
HINT:
Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY" Removal.

4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY
(a) Disconnect the connector.
NOTE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Remove the 2 clips.
(c) Remove the 9 bolts and curtain shield airbag assembly.