Removal

1UR-FSE EXHAUST: EXHAUST PIPE: REMOVAL

REMOVAL
CAUTION:
- Wear protective gloves when removing the exhaust pipe.
- The exhaust pipe is extremely hot immediately after the engine has stopped.
- Confirm that the exhaust pipe has cooled down before removing it.

1. REMOVE TAIL EXHAUST PIPE ASSEMBLY
(a) Remove the 2 bolts and 2 compression springs.





(b) Remove the tail exhaust pipe assembly from the 6 exhaust pipe supports.
(c) Remove the gasket from the front exhaust pipe assembly.
2. REMOVE EXHAUST PIPE DAMPER





(a) Remove the 2 bolts and damper.
3. REMOVE EXHAUST TAIL PIPE BAFFLE SUB-ASSEMBLY





(a) Using a plastic-faced hammer, uniformly tap off the exhaust tail pipe baffle sub-assembly.
4. REMOVE FRONT FLOOR COVER CENTER LH Removal
5. REMOVE FRONT FLOOR COVER CENTER RH Removal
6. REMOVE REAR NO. 1 FLOOR PANEL BRACE





(a) Remove the 4 bolts and panel brace.
7. REMOVE FRONT CENTER FLOOR BRACE





(a) Remove the 4 bolts and front center floor brace.
8. DISCONNECT HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
(a) Disconnect the grommets from the floor panel.





(b) Using SST, loosen the heated oxygen sensor, and the disconnect the sensor by hand.
SST: 09224-00010
9. DISCONNECT HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
(a) Disconnect the grommet from the floor panel.





(b) Using SST, loosen the heated oxygen sensor, and disconnect the heated oxygen sensor by hand.
SST: 09224-00010
10. REMOVE FRONT EXHAUST PIPE ASSEMBLY





(a) Remove the 4 bolts, 4 nuts and front exhaust pipe assembly.
(b) Remove the 2 gaskets from the exhaust manifold RH and exhaust manifold LH.