Replacement

TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER: REPLACEMENT

REPLACEMENT

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE ROOF HEADLINING ASSEMBLY
HINT: Refer to the instructions for removal of the roof headlining assembly Removal.

3. REMOVE TIRE PRESSURE MONITOR RECEIVER ASSEMBLY
(a) Disconnect the connector.





(b) Remove the bolt and the tire pressure monitor receiver assembly.
4. INSTALL TIRE PRESSURE MONITOR RECEIVER ASSEMBLY





(a) Install the tire pressure monitor receiver assembly with the bolt.
Torque: 7.5 Nm (77 kgf-cm, 66 in-lbf)
(b) Connect the connector.
5. INSTALL ROOF HEADLINING ASSEMBLY
HINT: Refer to the instructions for installation of the roof headlining assembly Installation.

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

7. REGISTRATION TRANSMITTER ID
HINT:
Registration.

8. INSPECT TIRE PRESSURE WARNING SYSTEM
HINT:
Test Mode Procedure.