Installation

SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSTALLATION

INSTALLATION
HINT: The installation procedures are the removal procedures in reverse order.





1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
(a) Insert the tip of the adjuster into the pillar, and align the adjuster's bolt hole to the pillar's bolt hole.
(b) Install the bolt.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY





(a) Install the seat belt with the 2 bolts. First install the upper bolt, and then install the lower bolt.
Torque: 7.5 Nm (77 kgf-cm, 66 in-lbf)
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)





(b) Connect the pretensioner connector labeled A, as show in the illustration.
(c) Connect the tension reducer connector labeled B.
(d) Connect the pre-collision safety connector labeled C.





(e) Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)





3. INSTALL CENTER PILLAR GARNISH
(a) Pass the outer belt anchor through the center pillar garnish.
(b) Attach the 3 clips and and claw to install the garnish. Then, install the 2 screws.
4. INSTALL CENTER PILLAR GARNISH LOWER Installation
5. INSTALL REAR DOOR SCUFF PLATE Installation
6. INSTALL FRONT DOOR SCUFF PLATE Installation
7. INSTALL FRONT SEAT ASSEMBLY Installation
8. CONNECT FRONT SEAT OUTER BELT ASSEMBLY Installation
9. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.