Installation

LIGHTING: LICENSE PLATE LIGHT ASSEMBLY: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.





1. INSTALL BACK DOOR GARNISH RETAINER SUB-ASSEMBLY
(a) Install the 2 clips and retainer to the luggage compartment door.
(b) Install the 2 screws.
2. INSTALL LICENSE PLATE LIGHT ASSEMBLY





(a) Install the license plate light and 2 screws to the luggage compartment door.





(b) Connect the connector.
3. INSTALL LUGGAGE COMPARTMENT DOOR GARNISH SUB-ASSEMBLY OUTSIDE





4. INSTALL LUGGAGE DOOR OPENING SWITCH ASSEMBLY
(a) Install the switch and 2 screws to luggage compartment door.
(b) Connect the connector.
5. INSTALL LUGGAGE COMPARTMENT DOOR COVER
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.