Stereo Component Amplifier Power Source Circuit

AUDIO / VISUAL: AUDIO AND VISUAL SYSTEM: Stereo Component Amplifier Power Source Circuit

Stereo Component Amplifier Power Source Circuit

DESCRIPTION

This circuit provides power to the stereo component amplifier.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. INSPECT FUSE (RAD NO. 1, RAD NO. 2, ACC)
(a) Disconnect the RAD NO. 1 and RAD NO. 2 fuses from the engine room No. 1 junction block.
(b) Disconnect the ACC fuse from the main body ECU RH.
(c) Measure the resistance of the fuses.
Standard resistance:
Below 1 Ohms
NG -- REPLACE FUSE
OK -- Continue to next step.

2. CHECK WIRE HARNESS (AMPLIFIER - BATTERY AND BODY GROUND)

(a) Disconnect the U29, U31 and U42 amplifier connectors.
(b) Measure the resistance of the wire harness side connector.
Standard resistance:
for CD changer models

for DVD changer models

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE