U1110

CAN COMMUNICATION: CAN COMMUNICATION SYSTEM: U1110: Lost Communication with Clearance Sonar Module

DTC U1110 - Lost Communication with Clearance Sonar Module

DESCRIPTION





HINT: For vehicles with 1UR-FSE and intuitive parking assist system.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK DTC
(a) Check for DTCs.
HINT: If CAN No.2 bus DTC U1002 is output, troubleshoot for U1002 and check for malfunctions in the CAN main bus circuit.

Result:






B -- GO TO DIAGNOSTIC TROUBLE CODE CHART
A -- Continue to next step.

2. CHECK CAN BUS LINE FOR DISCONNECTION (CLEARANCE WARNING ECU SUB BUS LINE)
(a) Turn the engine switch off.




(b) Disconnect the clearance warning ECU connector (A38).
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE CLEARANCE WARNING ECU SUB BUS LINE OR CONNECTOR (R1, R2)
OK -- Continue to next step.

3. CHECK WIRE HARNESS (IG, E)




(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:





(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE CLEARANCE WARNING ECU