Removal

PARKING BRAKE: PARKING BRAKE PEDAL: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE FRONT SEAT ASSEMBLY
HINT: Refer to the instructions for Removal of the front seat assembly Removal.

3. REMOVE REAR SEAT CUSHION ASSEMBLY Removal
4. REMOVE AIR NO.6 DUCT REAR

(a) Remove the 2 plugs, 2 screws and air No.6 duct rear.
5. REMOVE FRONT DOOR SCUFF PLATE Removal
6. REMOVE FRONT DOOR OPENING TRIM COVER
7. REMOVE REAR DOOR SCUFF PLATE Removal
8. REMOVE CENTER PILLAR LH GARNISH LOWER Removal
9. REMOVE CONSOLE UPPER PANEL GARNISH FRONT Removal
10. REMOVE FRONT ASH RECEPTACLE ASSEMBLY Removal
11. REMOVE INSTRUMENT PANEL FINISH LH PANEL END Removal
12. REMOVE INSTRUMENT PANEL FINISH RH PANEL END Removal
13. REMOVE CONSOLE BOX PLATE Removal
14. REMOVE CONSOLE BOX REGISTER ASSEMBLY Removal
15. REMOVE CONSOLE BOX Removal
16. REMOVE INSTRUMENT SIDE PANEL Removal
17. REMOVE INSTRUMENT PANEL UNDER NO.1 COVER SUB-ASSEMBLY Removal
18. REMOVE INSTRUMENT PANEL SAFETY NO.1 PAD SUB-ASSEMBLY Removal
19. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY Removal
20. REMOVE ACCELERATOR PEDAL (for 2WD)
21. REMOVE FRONT FLOOR SILENCER PAD (for 2WD)
22. REMOVE AIR NO.2 DUCT REAR
23. REMOVE FRONT FLOOR BRACE CENTER (for 2GR-FSE) Removal
24. DISCONNECT HEATED OXYGEN SENSOR (for 2GR-FSE) Removal
25. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 2GR-FSE) Removal
26. REMOVE FRONT FLOOR HEAT NO.1 INSULATOR (for 2GR-FSE) Removal
27. REMOVE REAR PROPELLER SHAFT ASSEMBLY (for 2GR-FSE) Removal
28. REMOVE FRONT FLOOR COVER CENTER LH (for 1UR-FSE)
29. REMOVE FRONT FLOOR COVER CENTER RH (for 1UR-FSE)
30. REMOVE REAR NO. 1 FLOOR PANEL BRACE (for 1UR-FSE) Removal
31. REMOVE FRONT CENTER FLOOR BRACE (for 1UR-FSE) Removal
32. DISCONNECT HEATED OXYGEN SENSOR (for 1UR-FSE) Removal
33. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 1UR-FSE) Removal
34. REMOVE FRONT FLOOR HEAT NO. 1 INSULATOR (for 1UR-FSE) Removal
35. REMOVE AIR GUIDE PLATE OUTSIDE RH (for 1UR-FSE) Removal
36. REMOVE REAR PROPELLER SHAFT ASSEMBLY (for 1UR-FSE) Removal
37. REMOVE DASH PANEL INSULATOR NO.3 PAD
38. REMOVE CENTER AIRBAG SENSOR ASSEMBLY Removal
39. REMOVE FRONT FLOOR REAR UPPER SUB PANEL

(a) Turn back the floor carpet in order to remove the front floor rear upper sub panel.
(b) Disengage the 6 clamps and remove the 4 bolts and front floor rear upper sub panel.
40. REMOVE PARKING BRAKE PEDAL

(a) Remove the parking brake return with damper spring.

(b) Remove the 2 bolts and separate the parking brake No.2 and No.3 cable assemblies from the parking brake equalizer.

(d) Remove the parking brake equalizer from the parking brake No.1 cable assembly.
(e) 2WD:
Remove the 2 bolts and 3 nuts, and separate the parking brake No.1 cable assembly from the body.

(f) 4WD:
Remove the 2 bolts and 4 nuts, and separate the parking brake No.1 cable assembly from the body.

(g) Remove the 2 nuts and separate the instrument panel junction block assembly.

(h) Disconnect the connector.
(i) Remove the 3 nuts and parking brake pedal from the body.